Acura Legend Electrical Steering Lock Replacement
SRS wire harness is routed near the steering lock assembly
All SRS wire harness and connectors are colored yellow. Do not electrical test equipment on these circuit. CAUTION: Be careful not to damage SRS wire harness when servicing the steering lock.
1. Remove the steering column covers.
2. Center punch each of the 2 shear bolts and drill their heads off with a 311 6 in. drill bit.
CAUTION: Do not damage the switch body when removing the shear bolt heads.
3. Remove the shear bolts from the switch body.
2. Center punch each of the 2 shear bolts and drill their heads off with a 311 6 in. drill bit.
CAUTION: Do not damage the switch body when removing the shear bolt heads.
3. Remove the shear bolts from the switch body.
4.Install the new ignition switch without the key inserted.
5. Loosely tighten the new shear bolts.
NOTE: Make sure the projection on the ignition switch is aligned with the hole in the steering column.
6. Insert the ignition key and check for proper operation of the steering wheel lock and that the ignition key turns freely.
7. Tighten the shear bolts until the hex heads twist off
5. Loosely tighten the new shear bolts.
NOTE: Make sure the projection on the ignition switch is aligned with the hole in the steering column.
6. Insert the ignition key and check for proper operation of the steering wheel lock and that the ignition key turns freely.
7. Tighten the shear bolts until the hex heads twist off
没有评论:
发表评论