A heat shield has been installed on all 3000 series tractors for 1999. The heat shield prevents the exhaust gases from browning the grass. Use kit #7593927. See Service Advisory CC-371.
1. Remove both of the hex bolts and lock nuts securing the front bumper to the frame using a 3/4" socket and a 3/4" wrench.
2. Remove the bumper.
3. Slide the muffler shield over the exhaust pipe and rotate it into position
NOTE: Align all three holes in the top of the muffler shield with the existing shield. Also, the muffler shield will be slanting towards the bottom of the front grill assembly
4. Secure the muffler shield with three sheet metal screws.
NOTE: Use a long flat blade screwdriver through the air holes in the grill to tighten the sheet metal screws securely.
5. Install the bumper.
LIFT LINK
The lift link has been modified by strengthening the powder metal that connects the lift lever to the hydraulic valve for 1999.
CHECK VALVE
For 1999, a check valve will be installed to the hydraulic valve to prevent the decks and other attachments from leaking down during and after usage.
LIFT STOP BRACKET
A lift stop bracket will be installed on the left hand side of the deck to prevent the deck from hanging up during operations. Use kit #759-3927.
ROLLER HEIGHT ADJUSTER
The rear roller height adjustment mechanism will be changed for 1999. A newly designed detent pin will
replace the old one, preventing the loss of cutting height during operations. Use kit #759-3928.
FRONT DECK HANGER ASSEMBLY
The front roller bracket has been redesigned to prevent the front lift rod from detaching during operation.
SEAT IMPROVEMENTS
A safer seat spring, part number 732-0869, can be
installed to level the seat for petite operators. In addition, the seat part number 757-3010A, is now made out of a softer material for better operator comfort.
The lift link has been modified by strengthening the powder metal that connects the lift lever to the hydraulic valve for 1999.
CHECK VALVE
For 1999, a check valve will be installed to the hydraulic valve to prevent the decks and other attachments from leaking down during and after usage.
LIFT STOP BRACKET
A lift stop bracket will be installed on the left hand side of the deck to prevent the deck from hanging up during operations. Use kit #759-3927.
ROLLER HEIGHT ADJUSTER
The rear roller height adjustment mechanism will be changed for 1999. A newly designed detent pin will
replace the old one, preventing the loss of cutting height during operations. Use kit #759-3928.
FRONT DECK HANGER ASSEMBLY
The front roller bracket has been redesigned to prevent the front lift rod from detaching during operation.
SEAT IMPROVEMENTS
A safer seat spring, part number 732-0869, can be
installed to level the seat for petite operators. In addition, the seat part number 757-3010A, is now made out of a softer material for better operator comfort.
FRONT MOWER DECK HEIGHT ADJUSTER
The front mower deck height adjuster pins have been changed from ball detent pins to quick pull pins.
STEERING WHEEL
The thickness of the steering wheel has been increased for operator comfort
The thickness of the steering wheel has been increased for operator comfort
Old Style Steering Wheel
New Thicker Steering Wheel
ROCK SHAFT ASSEMBLY FOR 3 POINT HITCH
190-365-100
The cylinder arms have been redesigned with two V sections cut out to allow for clearance of the clevis nut
on the cylinder shaft. See Service Advisory CC-364
190-365-100
The cylinder arms have been redesigned with two V sections cut out to allow for clearance of the clevis nut
on the cylinder shaft. See Service Advisory CC-364
没有评论:
发表评论